-
1.0 Fall Protection
-
1.1 Lesson Selection (Main Hub)
-
1.2 Lesson One - Gear Selection
-
1.3 Lesson Two - Training Room
-
1.4 Lesson Three - Equipment Retrieval
-
-
2.0 Confined Space
-
2.1 Lesson Selection (Main Hub)
-
2.2 Lesson One - Gear Selection
-
2.3 Lesson Two - Training Room
-
2.4 Lesson Three - Gas Leak
-
-
3.0 Lockout Tagout (LoTo)
-
3.1 Lesson Selection (Main Hub)
-
3.2 Lesson One - Gear Selection
-
3.3 Lesson Two - Training Room
- About Training Room
- Setup 1: Select all equipment needing LoTo - Part 1
- Setup 2: Select all equipment that needs LoTo - Part 2
- Setup 3: Select all equipment that needs LoTo - Part 3
- Setup 4: Radio to notify affected workers
- Setup 5: Apply and remove LoTo - Circuit Breaker Switch and Valve
- Setup 6: Release residual energy and verify
- Scoring
-
3.4 Lesson Three - Factory Site
- About Factory Site
- Step 1: Use Radio to Notify Affected Employees
- Step 2: Turn off the Power Switch, and Turn off Circuit Breaker Switch 3, then LoTo
- Step 3: Confirm Electrical Power Source Is Turned off
- Step 4: Release any Residual Energy
- Step 5: Services the Pump with the Wrench
- Step 6: Remove LoTo, and Open Main and Residual Pressure Valve
- Step 7: Remove LoTo and Turn on Circuit Breaker Switch 3
- Step 8: Notify Coworkers that Work Is Done
- Step 9: Power on the Pump
- Scoring
-
- Contact Us
Setup 4: Radio to notify affected workers
The following appears on the console screen:
Before beginning service work on equipment, you need to notify all affected employees of your work. Please take the radio from your belt and use it by pressing the button with your other hand.
When the trainee presses NOTIFY, the following voice over plays:
Shutting down unit for repairs.
After trainee presses NOTIFY, the following text appears on the console screen:
You can put away the radio back to your belt now. Take the wrench from the belt and hold it in your hand.
After the trainee has the wrench, the following will appear on the console screen:
Service the hydraulic press touching it with the wrench. At the moment, the machine is completely disconnected from any power source so it's safe to service.
Touch with wrench will appear in blue above the hydraulic press, and will disappear once the trainee uses the wrench on the hydraulic press.
When the trainee uses the wrench on the hydraulic press, a green circle will appear, followed by a check mark when the action is completed, and a positive beep will play.
The following appears on the console screen:
Good job! Now that you're done, you can put away the wrench on your belt and take the radio again. Use it to notify affected employees that you've finished the work.
After trainee presses NOTIFY after servicing the hydraulic press, the following voice over plays:
Bringing unit back online.
The setup will be complete.
The setup is marked as failed if the radio or wrench was lost, or if the trainee uses the wrench on the hydraulic press before affected workers have been notified.